Detail 01
13 in.
Fits a shell measuring 13 inches across. A 12 will leave it loose, a 14 will not seat at all.

Independent shopping perspective
A 13-inch tom head at the low end of the price range. For drummers doing routine replacement on a mid-sized tom without spending much.

Strong match
Consider the trade-offs
What matters in use
Catalog numbers tell only part of the story. These are the details most likely to change how this product feels, sounds, or fits into a setup.
Detail 01
Fits a shell measuring 13 inches across. A 12 will leave it loose, a 14 will not seat at all.
Detail 02
Sized and built for toms rather than snare or kick, where tension and stick load are different.
Detail 03
The cheapest of the three sizes here. Re-heading a whole rack of toms stays under a modest total.
Detail 04
One head, one drum side. Buy per drum, not per kit.
Detail 05
Priced for regular replacement rather than as a long-term investment head on a recording kit.
Final check
Product questions
Straight answers to the questions shoppers most often ask about this product.
The drum. Heads are named for the shell diameter they fit, so a 13-inch head goes on a 13-inch tom. Measure across the shell, not the hoop.
Yes. Tension rods have to come off to remove the old head and go back on evenly to tune the new one. No key is included here.
It is a 13-inch tom head, so it will physically fit either side of a 13-inch tom. Resonant sides are usually tuned lighter than the batter side.
It sits in the budget tier of the line. It is aimed at routine replacement rather than at specialty designs with added dots or coatings.