Detail 01
Male IEC to female IEC
This links fixture to fixture in a daisy chain. It does not plug into a wall; you still need an Edison-to-IEC cable to start the run.
Product detailSKU #1308322964338
ACCU CABLEECCOM-10 AC Extension Cable
1/2
Independent shopping perspective
The Korena take
A 10-foot IEC-to-IEC extension for daisy-chaining lighting fixtures. Buy it to bridge gaps between lights already using IEC power in and out.
Strong match
Who this is for
- Extending reach between two fixtures on a long truss
- Mobile setups where fixture spacing changes venue to venue
- Replacing a short jumper that forces awkward rigging positions
Consider the trade-offs
When to look elsewhere
- Powering a fixture from a wall outlet, which needs an Edison plug end
- High-current runs where 16-gauge is undersized for the load
- Anyone needing a locking connector for permanent installs
What matters in use
The specifications, translated
Catalog numbers tell only part of the story. These are the details most likely to change how this product feels, sounds, or fits into a setup.
Detail 02
16/3 gauge
Three conductors at 16 gauge, so it carries a grounded connection. Watch total amperage when chaining several fixtures on one run.
Detail 03
10-foot length
Covers wider fixture spacing than typical 3-foot jumpers, useful when lights sit far apart on a long truss span.
Detail 04
Three-conductor
Includes a ground path, which matters for metal-bodied fixtures and reduces hum in nearby audio lines.
Detail 05
IEC connectors
Friction-fit, not locking. They can pull free if the cable gets tugged, so dress and secure your runs.
Final check
Know before you order
- 01You still need an Edison-to-IEC cable to feed the first fixture from a wall
- 02Add up fixture wattage before chaining; do not exceed the run's capacity
- 03IEC connectors do not lock, so tie off cable at the fixture to prevent pull-out
Product questions
Before you decide
Straight answers to the questions shoppers most often ask about this product.
01Can I plug this into a wall outlet?
No. Both ends are IEC. Use an Edison-to-IEC power cable to feed the first fixture, then chain from there with this one.
02How many lights can I daisy chain?
Depends on each fixture's wattage and the circuit's rating. Add up total draw and stay within your breaker and cable capacity.
03Is 16 gauge thick enough?
It handles typical LED fixture chains. For high-wattage conventional lights or long chains, step up to a heavier gauge.
04Will this fit any fixture with an IEC port?
Standard IEC ports, yes. Some fixtures use locking IEC connectors, which need a matching locking cable instead.
Reference
Full specifications
The complete catalog record, organized around the decisions musicians make when comparing gear.
1 detailsBody & build
- Color
- Black
1 detailsConnections & power
- Connectors
- Male IEC to Female IEC
1 detailsSize & weight
- Length
- 10 feet
1 detailsOther
- Gauge
- 16/3
